ShanghaiBeijingChinaAsiaGuideItineraryTransportationTravel TipsTravel Advisory
Show All

China Power Plug: Outlet Types and What Fits, by Country

cover

Your first Chinese wall socket will either take the plug in your hand or refuse it, and which one happens has less to do with China than with the country stamped on your charger. The China power plug question sounds like it needs a wall chart, but the answer is usually printed on the charger in your bag, as one letter.

 

Mainland China runs two plug types, A and I, under the national standard GB 1002-2024, and the sockets themselves follow GB 2099.1 and GB 1002. Compliant plugs carry the CCC mark, the Chinese certification stamp, which is the quickest thing to look for on anything electrical sold inside the country. The supply behind every socket, whatever shape the holes are, is 220 volts at 50 hertz. Read the input figures on anything that heats up before you plug it in, because a hairdryer or a razor built for 110 volts will overheat here and can be damaged for good.

 

Those letters come from an IEC naming guide that grouped broadly compatible plugs, and the guide never promised that two plugs sharing a letter would fit each other. That caveat earns its keep here, because China's Type I and Australia's Type I are close relatives with opposite habits. The mapping below runs country by country, so read your own plug first. Travelers on China vacation packages tend to move between city hotels every few nights, and the socket by the desk is the one that decides your first evening.

China's Socket Set in Plain Terms

Two shapes cover the country, with a third still hiding in older walls. The trick is telling which of the three you are looking at.

 

The Standard Pair, A and I

 

Type A is the flat two-pin shape, unearthed, the same family as the American NEMA 1-15 plug, and China uses those sockets and plugs for Class II appliances, meaning gear with no metal case to touch. One detail catches North American travelers: a polarized plug, the kind with one prong wider than the other, does not go into a Chinese Type A socket. The blade width is what settles it, so compare the two prongs before you trust the outline of the plug.

 

Type I is the three-pin shape, two angled flat pins forming a V with a vertical earth pin between them. Chinese versions are rated 10 or 16 amps at 250 volts, and the 10-amp pins measure 1.55 mm by 6.4 mm. Those dimensions are close enough to the Australian and Argentine 10-amp pins that the three families interlock, which is why an Australian plug seats and a European round pin does not.

 

Which Way Up the Earth Pin Sits

 

In China the earth contact sits above the power pins. In Australia and Argentina it usually sits below, and Wikivoyage's guide to electrical systems sums it up by saying the Chinese plug is upside down and has slightly longer pins than the Australian one. Same letter, different orientation, so the plug hangs the other way round from the one you know. The 16-amp version widens the pin spacing, which shuts it out of Chinese 10-amp sockets and out of every Australasian one, so amperage is worth a glance.

 

Where the Round-Pin Socket Went

 

Type C, the Europlug, used to have a home here. Older versions of GB 1002 defined a hybrid socket with an unearthed section that took A and C plugs beside an earthed section for Type I. Since GB/T 1002-2021, Type C no longer meets the national standard, and firms stopped producing, selling and installing them. The old plates did not disappear, though, and plenty of walls still carry them, so a round-pin socket is a bonus rather than a plan.

 

Shutters, and the Pin That Opens Them

 

Many Chinese sockets have shutters that stay closed until the longer earth pin goes in first, or until both live pins are pushed in together, which keeps small fingers out. Chinese Class II plugs trip them with an unwired dummy earth pin, a trick in use since 2008 on the 16-amp version and since 2021 on the 10-amp one. Line the pins up square and push straight, because levering a plug sideways will not open a shutter.

Read Your Own Plug's Letter First

Find the letter that matches your plug, then read across, since the third column is the short answer and the paragraphs below explain the near misses.

 

Country or region Plug letters At a Chinese outlet
United States A, B A fits if unpolarized
Japan A, B A fits if unpolarized
Taiwan A, B A fits if unpolarized
Thailand A, B, C, O A fits if unpolarized
Vietnam A, B, C, F A fits if unpolarized
Australia, New Zealand I 10-amp I fits
Argentina I 10-amp I fits
United Kingdom G, D, M Needs an adapter
Ireland G Needs an adapter
Hong Kong, Macau G, D, M Needs an adapter
Singapore C, G, M Needs an adapter
India C, D, M Needs an adapter
France, Belgium C, E Needs an adapter
Germany, Netherlands, Spain C, F Needs an adapter
Italy C, F, L Needs an adapter
Switzerland C, J Needs an adapter
South Korea C, F Needs an adapter

 

The Rows That Say Yes

 

Australia and New Zealand head the friendly list because their standard and China's were built around the same 10-amp pin dimensions, and Australian three-pin plugs are generally supported in China as a result. Argentina shares that geometry, and the difference there is polarity, which runs the other way from the Chinese version.

 

The flat two-pin rows are the conditional ones. A Type A socket in China follows the NEMA 1-15 pattern, so an unpolarized plug from the US, Japan, Taiwan, Thailand or Vietnam slides in. A polarized plug with one wider prong is refused, however familiar the blades look.

 

The Lines That Say No

 

Type G, the British plug, is three rectangular pins in a triangle with a fuse built into the plug body. The IEC counts more than 50 countries on the BS 1363 socket system, among them Hong Kong, Macau, Ireland, Singapore, Malaysia, Sri Lanka and the UAE, and none of them is China. A British plug has no route into an A or I socket without a shape changer, and Wikivoyage notes that universal extension cords taking several shapes, British included, are often used in China.

 

Continental Europe does not fare better. Type E and F, the French and Schuko round-pin plugs, are absent from China's national set, and the legacy dual sockets that accepted them did so without connecting earth, leaving live pins exposed when a plug sits partway in. Type D, the older British round three-pin, is used in India and about 40 other countries, with Type M in about 15, and pressing a C, E or F plug into a D socket is workable but unsafe. Swiss J, Italian L, Danish K, Brazilian N and Thai O have no Chinese counterpart at all.

 

Why the Letter Stops Short of a Promise

 

Wikipedia's plug article is blunt about the limits of the alphabet: a letter does not uniquely identify a plug within its type family, and it does not guarantee compatibility. A plug that wobbles or needs force should come straight back out. Physical compatibility does not settle voltage, frequency or current capacity, so the letter is the start of the check rather than the end of it.

Who Needs Nothing at All

The table above settles the easy half. The rest sits in two markings on your own plug: the current rating on its face, and whether an earth pin exists at all.

 

Arriving From Australia or New Zealand

 

The 10-amp Australasian plug comes closest to a native fit, since the pin dimensions were shared from the start, and it goes in upside down with the earth pin on the wrong side of the face. Current rating is the catch. Australasian sockets take plugs of equal or lower rating and never higher, and China's Type I comes in 10 and 16 amps, so a 10-amp plug travels without help; on a 15-amp plug the earth pin stands 9.08 mm tall instead of 6.35 mm. Check the rating stamped on the plug before you pack the appliance it belongs to.

 

Arriving From North America, Japan

 

A flat two-pin charger with two identical blades goes straight into a Chinese Type A socket, which covers phones, tablets and camera chargers. A Type B plug, with its round earth pin, has no counterpart in the Chinese set at all. A polarized two-pin fails for a different reason, one blade being wider than the other. Japanese pins run slightly shorter than American ones, a difference the letter does not record.

 

Arriving From Britain, Europe, India or the UAE

 

Nothing in this group goes in unassisted: British G, European E and F, Indian D and M, Swiss J and Italian L all need a shape changer. An itinerary that starts in the UAE and lands in China changes families in the air, so the block belongs in the bag you keep with you rather than in the one that goes into the hold.

 

Pack the block if your plug carries an earth pin from outside the Type I family, and pack it anyway if the route crosses into Hong Kong, Macau, or Singapore. On a multi-city China Tours route, that answer gets tested once per hotel.

Old Buildings and Legacy Sockets

The building you sleep in decides more than the city does. A property wired to the 2021 standard has separate plates; one that has never been rewired may still carry the hybrid plate, with an unearthed section for A and C plugs beside an earthed section for Type I.

 

What the Old Plate Really Accepts

 

Those hybrid plates also swallow French and Schuko E and F plugs, and they do it badly: no earth contact is made, and the live pins stay reachable with the plug partway in. A socket that takes your plug is not the same as a socket that fits it.

 

What to Do When a Plug Will Not Sit

 

Try another outlet before you try another room. Chinese sockets often refuse a plug that sits a fraction off, because the shutter opens for the longer earth pin or for two live pins at once, and a worn plate will not give. A run of city hotels can mix a refurbished tower with an older wing, and the desk usually knows which is which. Ask for a room on the newer side rather than forcing a plug, and on a multi-city Tours4fun China itinerary, make the request at each check-in.

Bathroom Fittings Outside the Mainland

One fitting is worth knowing about before you check in, and it belongs to the British wiring family rather than to China's socket set.

 

What a Shaver Socket Is Built For

 

The British wiring family has a separate bathroom fitting called a shaver socket, which takes the two-pin British shaver plug, BS 4573, or the 2.5-amp Europlug. Hotels in the UK, Ireland and Singapore may have one, and Ireland generally bans general purpose outlets in bathrooms and wet areas, so there the shaver socket is the bathroom option. Its 2.5-amp rating is the tell, and a shaver socket will not take a larger Type C plug: this is a fitting for a razor or a toothbrush, not for something that heats up.

 

Where Your Charger Belongs

 

On the mainland the room follows the national A and I set, so the block you sorted for the desk covers the room. In Hong Kong, Macau, Ireland or Singapore, read the bathroom fitting as a razor outlet rather than a place to charge, and keep the block for the desk.

What to Pack If You Are Unsure

If the China power plug letters still feel abstract, pack for shapes.

 

  • One block that covers several shapes. A single adapter taking A, C, G and I covers your own plug and the sockets you will meet in Hong Kong or Macau on the same trip.
  • A universal extension cord. Wikivoyage notes these are often used in China and handle a variety of plug shapes, British included, which gives you more outlets from the one that works.
  • The charger bricks, not just the cables. The brick is the part with the pins that have to meet the wall, so a cable on its own solves nothing.

 

If you do buy, note that A-to-C and C-to-G adapters are tiny and cheap while anything converting a Type G plug runs bulky. Rental power banks are common in China too, easing pressure on one socket.

 

Pack the block and skip the three single-shape adapters, because one item that works in every room beats a drawer of near misses.

FAQ

Which plug types will I meet in China?

Mainland China's national set is Type A and Type I under GB 1002-2024. Type A is the flat two-pin socket and Type I is the three-pin V. A legacy round-pin socket for the Europlug still turns up in older buildings, though it no longer meets the standard.

Will an Australian plug work in China?

A 10-amp Australian or New Zealand three-pin plug fits a Chinese Type I socket, because the pin dimensions are nearly identical. It sits upside down, with the earth pin on the other side of the face, and works regardless. Higher-rated Australasian plugs, and the Chinese 16-amp version, do not fit 10-amp sockets.

Do Hong Kong and Macau use the same sockets as the mainland?

No. Hong Kong and Macau run British BS 1363 and BS 546 sockets, so their set is Type G, D and M rather than A and I. A trip that pairs a mainland city with Hong Kong crosses two families, and one block covering both saves a purchase on arrival.

Why won't my polarized US plug fit?

Chinese Type A sockets follow the NEMA 1-15 pattern, and they refuse a plug with one blade wider than the other. A two-pin charger with two identical blades slides in, while a polarized lamp cord does not, so check the blades rather than trusting the familiar shape.

Summary

China's Socket Set in Plain Terms

Read Your Own Plug's Letter First

Who Needs Nothing at All

Old Buildings and Legacy Sockets

Bathroom Fittings Outside the Mainland

What to Pack If You Are Unsure

FAQ

America's 250th Anniversary Mega Sale

image